Ammonium nitrate is an efficient nitrogen fertilizer, but it is more demanding to keep in good physical condition than many other products. Bags that arrive free-flowing can set into hard blocks, or prills can crumble into fines that clog spreaders. Two properties explain most of this: the way the salt absorbs moisture and the way its crystal structure changes with temperature.
Moisture and critical relative humidity
Every soluble salt has a critical relative humidity (CRH): the humidity above which it starts drawing water from the air. Ammonium nitrate has a lower CRH than most common fertilizer salts, and its CRH drops as temperature rises. Published figures show it falling from roughly two-thirds humidity at 20 °C to around half at 40 °C. In a warm, humid store or on an open quayside, the air is often above that level.
When prills take up moisture, a thin film of saturated solution forms on their surface. If the temperature then drops or the air dries, that solution crystallises at the points where granules touch and bonds them together. Because the solubility of ammonium nitrate changes sharply with temperature, daily heating and cooling makes this cycle especially effective at forming cakes.
The crystal change near 32 °C
Solid ammonium nitrate exists in several crystal forms. One change happens at about 32 °C, a temperature that bags, stacks and containers easily pass through in warm climates. Each time the product crosses that point its crystals change volume. Repeated cycling causes internal stress, so prills swell, crack and eventually break into dust.
Trace water appears to make this transition easier and faster, so damp product suffers more. Crumbled prills have more surface area and more contact points, which in turn makes caking worse. Studies on related nitrate fertilizers have found caking tendency far lower when product is kept below the transition temperature.
What producers do
- Low moisture at bagging. Drying the product thoroughly reduces both caking and phase-change damage.
- Stabilising additives. Certain inorganic additives are incorporated into the melt to suppress the crystal change and keep prills intact through temperature swings.
- Anti-caking coatings. Fine mineral powders or coating agents reduce direct contact between granules and limit moisture uptake.
- Cooling before storage. Product is cooled after prilling or granulation so that it does not cake under its own heat.
What users and distributors can do
- Keep bags sealed until use. Lined, intact bags are the main barrier against humid air.
- Store in a dry, covered and ventilated building. Avoid direct sun on stacks, which drives temperature cycling through 32 °C.
- Limit stack height. Pressure at the base of a stack compacts product and increases caking; storage guidance in several countries also limits stack size for safety.
- Rotate stock. First in, first out keeps storage time short.
- Do not store on bare floors. Pallets keep bags off damp concrete.
- Reseal or use opened bags quickly. Part-used bags absorb moisture fast in humid weather.
Heat, humidity and time are the three enemies of ammonium nitrate quality. Reducing any one of them slows caking and breakdown.
Why physical quality matters
Caked or dusty product is harder to spread evenly, so nitrogen lands unevenly in the field. Fines can segregate in blends and drift during application. Lumps can block spreader mechanisms and bulk-blending equipment. Badly degraded material may also fall outside the particle-size limits in a purchase specification. Storage practice for ammonium nitrate also has a safety dimension, covered in a separate guide.
Checking quality on arrival and in purchase terms
When buying ammonium nitrate fertilizer, ask for moisture, particle size distribution and the presence of a conditioning agent to be stated on the certificate of analysis. Check bag construction, including the inner liner, and plan arrival for a time when dry, covered storage is ready. Nuroil supplies ammonium nitrate fertilizer with a CoA for each delivery; send your requirements through the quote form.


