Urea is one of the most widely used nitrogen sources in drip and sprinkler fertigation. It is very soluble, carries no salt load beyond its nitrogen, and is compatible with many other fertilizers. Making a good stock solution still takes some care, because urea behaves differently in a mixing tank from most other solid fertilizers.
Why the tank goes cold
Dissolving urea absorbs heat from the water: the process is endothermic. As urea goes into solution the temperature drops noticeably, and the colder the water becomes, the less urea it can hold and the more slowly the remaining solid dissolves. Published solubility tables show urea dissolving at well over its own weight per 100 kg of water at 20°C, but those figures assume the water stays at 20°C, which it does not in a farm tank.
Practical concentration limits
Because of the cooling effect, extension and industry guidance recommends working well below theoretical solubility:
- Australian fertilizer guidance gives a practical limit of about 25 to 30 kg of urea per 100 litres of solution, noting that higher figures are not realistically achievable on farm without heating and agitation.
- Victorian irrigation guidance recommends using solubility figures for 10°C regardless of ambient temperature, and favours conservative mixing ratios.
| Stock strength | Urea per 100 L solution | Approximate N per 100 L | Comment |
|---|---|---|---|
| Dilute | 15 kg | 6.9 kg | Dissolves quickly, low risk of recrystallisation |
| Moderate | 20 kg | 9.2 kg | Common working strength |
| Practical upper limit | 25 to 30 kg | 11.5 to 13.8 kg | Needs agitation and time; risk in cold weather |
Mixing procedure
- Fill the tank with about half to two thirds of the final water volume.
- Start agitation before adding urea.
- Add urea gradually rather than dumping full bags at once.
- Top up with water to the final volume.
- Keep stirring and allow the solution to warm back towards ambient temperature before injecting, so that all urea is dissolved.
- Check for undissolved crystals at the bottom of the tank before use.
Prilled urea, with its smaller particles, generally dissolves faster than granular urea and needs less agitation. Stock solutions that will stand for some time, especially overnight in cool weather, should be mixed weaker, because urea can crystallise out as the temperature falls.
Compatibility
Urea mixes readily with most soluble nitrogen and potassium fertilizers. A few cautions apply:
- Do not mix concentrated fertilizers directly with one another before adding water; dissolve each in water separately or add them one at a time to a filled tank.
- Calcium-containing fertilizers should be kept apart from phosphate and sulphate fertilizers in concentrated stock tanks, regardless of urea.
- Run a jar test with the actual water and products before mixing a new combination at full scale.
Working out injection rates
Each kilogram of urea dissolved supplies 0.46 kg of nitrogen. To deliver a target dose, divide the nitrogen required for the irrigated block by 0.46 to get the urea needed, dissolve it at a safe stock strength, and inject the whole stock over the middle part of the irrigation cycle. Starting injection after the system has filled and finishing before the end leaves time to flush the lines with clean water.
System care
- Filter the stock solution before injection.
- Run clean water through the system after fertigation to flush lines and emitters.
- Urea in irrigation water can encourage microbial growth in lines; regular flushing helps.
- Remember that urea converts to ammonium and then nitrate in soil, which has an acidifying effect over time, so monitor root-zone pH in long-term systems.
What to specify for fertigation supply
For fertigation, clean dissolution matters as much as nitrogen content. When enquiring for agriculture-grade urea, state that it is for fertigation and ask about water-insoluble matter, biuret (relevant if crops will also receive foliar sprays), prilled or granular form and any coating used. Nuroil supplies a certificate of analysis with each delivery and the product SDS on request through the quote form.



