Technical document

· PDF

Tell us who you are and the document downloads straight away. We use these details only to follow up on your requirement.

Samples & documents

What can we send you?

Tick what you need
Request a quote
NUROIL / POOL & DISINFECTION / ALGAECIDE

Pool algaecide.Stops algae early.

Liquid algaecide based on quaternary ammonium compounds, benzalkonium chloride or polyquat, dosed weekly beside chlorine to keep algae from taking hold.

  • Quat · polyquat
  • Liquid concentrate
  • Copper-free
  • Corrosive — use PPE
Pencil drawing of Pool Algaecide
BaseQuaternary ammoniumCAS 68424-85-1 (ADBAC)
AlgaecideQuat · polyquatKeeps algae from taking hold
HazardDangerUN 1903 or not regulated, per SDS
Active typeQuaternary ammonium, by formulation
Active contentTypically 10–60%, per TDS
FormClear liquid
pH, as suppliedAbout 6–8, per TDS
DensityAbout 1.0–1.1 g/cm³
Switch productPool water care
See the industry
01 THE MATERIAL

What is pool algaecide?

Pool algaecides are water-based solutions of algae-killing actives, most often quaternary ammonium compounds. Typical formulations use benzalkonium chloride (ADBAC), a surfactant quat, at about 10–50% active, or polyquat, a polymeric quat (WSCP), at about 10–60% active. The offered product’s TDS and SDS give its exact composition.

An algaecide supports chlorine rather than replacing it: a small weekly dose stops algae spores taking hold between chlorine doses, especially in warm, sunny water. Polyquat grades do not foam; benzalkonium grades cost less but can foam if overdosed. These are copper-free, so they do not stain.

Identity
Base
Quaternary ammonium
Type
Liquid algaecide
CAS
68424-85-1 (ADBAC)
Quat or polyquat pool algaecide
Why Algaecide
  • Prevents green waterA weekly maintenance dose stops algae establishing between chlorine doses.
  • Less shock dosingFewer algae blooms means fewer heavy chlorine shocks and less downtime.
  • No copper stainsQuat and polyquat formulations carry no copper, so they do not stain surfaces or tint hair.
  • Documented qualityEach offered product comes with its TDS, Certificate of Analysis and safety data sheet.
What Nuroil does on every order

Why choose algaecide from Nuroil?

  • Checked against the batch CoA

    Active content, pH and appearance are reviewed on the batch certificate before loading.

  • Formulation stated

    The active, its strength and the dose rate are confirmed on the TDS with the offer.

  • Sealed, labelled containers

    Cans, drums and IBCs closed and labelled to the SDS.

  • One desk, firm offers

    FOB, CFR or CIF from our Sharjah trade desk, usually within 24 hours.

02 TECHNICAL DATA

Technical specification.

Active ingredient
Benzalkonium chloride (ADBAC) or polyquat (WSCP), per TDSProducer formulation
Active content
Typically 10–60%, by formulationTwo-phase titration
pH (as supplied)
About 6–8pH meter
Density at 20 °C
About 1.0–1.1 g/cm³Hydrometer
Appearance
Clear, colourless to pale yellow or tinted liquidVisual
Foaming
Low (polyquat); can foam if overdosed (ADBAC)
03 HOW IT IS MADE

From quat actives to a pool liquid.

Quaternary ammonium actives are made by alkylating tertiary amines, then supplied as concentrates. The pool algaecide is blended from the concentrate and treated water, adjusted for pH, sometimes tinted, then filtered and filled.

  1. 01

    Quat actives

    Benzalkonium chloride or polyquat concentrate is the starting material.

  2. 02

    Blending

    The active is diluted with treated water to the product strength.

  3. 03

    Adjusting

    pH is adjusted and a colour may be added for identification.

  4. 04

    Testing and filling

    Each batch is tested for active content and filled into cans, drums or IBCs.

Quat activesWaterBlendLiquid algaecide01Quat actives02Blending03Adjusting04Testing and filling
04 APPLICATIONS

Where it keeps water clear.

05 SAFETY & HANDLING

Corrosive concentrate. Protect your eyes.

This summary does not replace the Safety Data Sheet. Classification depends on the formulation and strength; review the product SDS and site procedure before first handling.

Danger
  • H302 Harmful if swallowed (typical, per SDS).
  • H314 Causes severe skin burns and eye damage (concentrates; H318 at lower strength, per SDS).
  • H410 Very toxic to aquatic life with long lasting effects (typical, per SDS).
UN
1903 or not regulated, per SDS
Class
8, corrosive, per SDS
  1. 01
    Protect skin and eyes

    Stronger quat concentrates burn skin and eyes; weaker ones cause serious eye damage. Wear gloves and eye protection.

  2. 02
    Dose into the pool, not with other chemicals

    Never mix with chlorine products or other pool chemicals in a container; add each separately to the pool water.

  3. 03
    Keep it out of drains

    Quats are very toxic to aquatic life; contain spills and do not wash them to drains.

  4. 04
    Dose to the label

    Overdosing benzalkonium grades causes foam and can make water cloudy.

  5. 05
    Exposure response

    Rinse eyes and skin with plenty of water for several minutes and seek medical attention; do not induce vomiting if swallowed.

Closed, shaded and frost-free.
Shelf lifeTypically 2 years

Quat algaecides are stable when kept closed, out of the sun and above freezing. Confirm the producer’s shelf life with the offer.

  • Keep containers closedReseal after use and keep the original label.
  • Shaded, above freezingOut of direct sun and away from heat; do not let it freeze.
  • SegregateApart from chlorine products and other oxidisers, and from food and drink.
  • First in, first outUse the oldest stock first and keep the batch label with each lot.
Plan documentation early.
  • HS code3808.94
  • CAS number68424-85-1
  • CAS number31512-74-0
  • UN numberUN 1903
GHS
Typically harmful if swallowed; skin burns or serious eye damage, by strength; very toxic to aquatic life; per SDS
Transport
Corrosive grades often UN 1903, disinfectant, liquid, corrosive, n.o.s., class 8; dilute grades may be not regulated; per SDS
Biocide registration
Algaecides need product approval in many markets; confirm the destination’s rules
National regulations
Confirm the destination’s import and dangerous-goods requirements
06 PACKING OPTIONS

Choose your packing.

Pack sizes, formulation and container loads depend on the producer; the offer confirms them.

07 BEFORE YOU ORDER

Frequently asked questions.

01Does algaecide replace chlorine?

No. It prevents algae between chlorine doses. Chlorine, or another sanitiser, is still needed to disinfect the water.

02What is in it?

Typical pool algaecides are water solutions of benzalkonium chloride or polyquat. Strength and additives vary by producer; the offered product’s TDS and SDS give the exact composition.

03Why does my pool foam?

Benzalkonium chloride is a surfactant and foams when overdosed. Dose to the label, or choose a polyquat grade, which does not foam.

04Can it be added with chlorine?

Add them separately and never mix concentrates. Many producers advise dosing algaecide some hours after a chlorine shock, when the chlorine level has dropped back.

05Is it dangerous goods for shipping?

Stronger quat concentrates are usually class 8 corrosive, UN 1903; weaker products may be not regulated. The product SDS decides, and we prepare the documents to match.

06What is the HS code?

Formulated algaecides are usually declared under HS 3808.94 (disinfectants); some are declared under 3808.99. Confirm with the product and destination.

07What documents come with a shipment?

A TDS, Certificate of Analysis and Safety Data Sheet, with the Certificate of Origin and dangerous-goods declaration as required.

LET’S PLAN YOUR SUPPLY

Discuss your algaecide requirement.

Include the type (quat or polyquat), strength, quantity, packing and destination for a tailored offer. We reply with a firm FOB, CFR or CIF offer, usually within 24 hours.

  • Cans, drums or IBCs
  • Quat or polyquat
  • FOB, CFR or CIF
Request a quote
LET’S TALK ABOUT YOUR REQUIREMENTS

Your next shipment starts here.

Request a quote