Technical document

· PDF

Tell us who you are and the document downloads straight away. We use these details only to follow up on your requirement.

Samples & documents

What can we send you?

Tick what you need
Request a quote
Guide3 min read8 sections

Knowledge centre · Industrial chemicals

Storing, heating and packing refined glycerine

5%: moisture control, tank materials, gentle heating for pumping, and drum, IBC and bulk packing.

Written by the Nuroil trade desk, Sharjah

On this page · 8 sections
  1. 01Properties that drive handling
  2. 02Tank and equipment materials
  3. 03Keeping moisture out
  4. 04Heating for transfer
  5. 05Packing options
  6. 06Receiving a delivery
  7. 07Shelf life and stock checks
  8. 08Agreeing packing and documents

Refined glycerine is not hazardous in the way acids and alkalis are, but it is easy to spoil. It absorbs water from the air, thickens sharply in the cold and darkens if overheated. For USP grades, storage practice also protects the identity chain that regulators expect. This guide covers storage, heating and packing.

Properties that drive handling

  • Hygroscopic: glycerol readily takes up moisture from humid air, lowering its purity.
  • Very viscous: about 1.4 Pa·s at 20°C, many times thicker than water, and much thicker when cold.
  • Melting point around 18°C: pure glycerine tends to supercool rather than crystallise, but it can solidify after long cold storage.
  • Heat-sensitive colour: long periods at elevated temperature raise colour.
  • Combustible but not flammable at ambient temperature; check the SDS for flash point and fire guidance.

Tank and equipment materials

Stainless steel is the standard material for tanks, pumps and lines carrying pharmaceutical or cosmetic glycerine. Distributor handling sheets also allow tanks lined with suitable food-grade coatings. Plain carbon steel can add iron and colour and is better avoided for high grades. Use hygienic gaskets and keep lines dedicated to glycerine where possible.

Keeping moisture out

  • Keep drums and IBCs tightly closed and store indoors.
  • Fit bulk tanks with a nitrogen blanket or a desiccant breather. Some distributor specifications call for a nitrogen blanket for longer storage periods.
  • Do not leave filling hatches open during transfers.
  • Check water content on long-held stock before use in sensitive products.

Heating for transfer

Warming lowers viscosity and makes pumping practical. One distributor handling guide recommends roughly 35 to 52°C for handling and warns against going above the upper figure, while advising cooler conditions for long-term storage to avoid colour change. Practical points:

  • use low-temperature hot water or thermostatically controlled electric tracing rather than live steam;
  • heat only for transfer, then let the product cool back towards room temperature;
  • insulate lines so short warm-ups are enough;
  • recirculate gently and filter at load-out if the product goes straight to filling.

Packing options

PackingSuitsNotes
Plastic or lined steel drumsCosmetic, pharma and small industrial usersSealed; each drum keeps its own lot identity
IBCsRegular medium-volume usersViscous product drains slowly in cool weather; allow warm-up
FlexitanksBulk industrial usersConfirm liner suitability and receiving heat if needed
Stainless ISO tanksBulk pharma and food gradesClean, dedicated or certified-clean tanks; heating coils useful

For USP glycerine, prefer packing where each container is sealed and labelled with the lot number, so per-container identity testing can be carried out on arrival.

Receiving a delivery

  1. Check seals, labels and lot numbers against the CoA and packing list.
  2. Inspect drums and IBCs for damage, leaks or signs of water ingress.
  3. Sample according to your quality procedure; for medicines this means each container.
  4. Quarantine the lot until results are approved, then move it to dry, temperature-moderate storage.

Shelf life and stock checks

Stored sealed, dry and at moderate temperature, refined glycerine keeps well. Retest water, colour and odour on stock that has been held a long time or exposed to heat. Record lot numbers through to production use, and never top up a part-used drum from another lot, since that breaks traceability.

Sealed, dry and only gently warmed: refined glycerine stays within specification when moisture and heat are controlled.

Agreeing packing and documents

State the grade, the packing you can receive, any heating available at your site, and whether you need nitrogen-blanketed or dedicated tanks for bulk. Ask for the SDS and a CoA per lot. Nuroil supplies FOB UAE with CFR or CIF on request; send details through request a quote.

KEEP READING

More from the Knowledge Centre.

STILL HAVE A QUESTION?

Ask the people who trade it every day.

Our trade managers answer technical and commercial questions about grades, specifications, packing and shipping.

LET’S TALK ABOUT YOUR REQUIREMENTS

Your next shipment starts here.

Request a quote