SLES is a stable material when stored sensibly, but heat, cold, contamination and long storage can all change its quality. The 70% paste and the 28% liquid also behave differently in drums and tanks. This guide covers storage conditions, shelf life, common quality problems and the packing options used in trade.
Storage conditions
- Temperature: store in a cool, shaded place, protected from direct sun and from frost. Producer sheets commonly advise room temperature storage away from strong light and heat.
- Containers: keep in the original closed containers. Opened drums should be resealed to keep out dust, water and insects.
- Indoor storage: drums left in the sun can heat up well above ambient, especially dark-coloured ones, and those left out in rain can collect water on the lid that enters when opened.
- Materials: plastic (HDPE) and stainless steel are suitable for contact. Avoid unlined mild steel for long-term storage.
What can go wrong in storage
| Problem | Cause | Prevention |
|---|---|---|
| Falling pH, sulphurous odour | Hydrolysis of the ether sulphate, speeded by heat and acidity | Avoid high storage temperatures; check pH on older stock |
| Cloudiness or thickening in cold weather | Low temperature reduces solubility | Store above freezing; warm gently and mix before use |
| Musty odour, slime, gas in drum | Microbial growth, mainly in diluted liquid | Keep sealed, use clean tools, ask about preservation |
| Skin or crust on paste surface | Water evaporation from open container | Keep lids closed; remove crust before use |
| Separation or layering | Temperature cycling, long storage | Mix before sampling and use |
Hydrolysis
Alkyl ether sulphates can slowly break down in water to the parent alcohol ethoxylate and acidic sulphate. The reaction is faster at high temperature and low pH, and because it produces acid, it can accelerate itself once started. Concentrated material held hot for long periods is most at risk. Producers buffer their product to a neutral or mildly alkaline pH for this reason. If a drum has been stored hot, check its pH before use.
Microbial risk
Many SLES grades are supplied unpreserved. The 70% paste has little free water and is less hospitable to micro-organisms. The 28% liquid contains much more water and, if unpreserved, can support bacterial or fungal growth once opened and contaminated. Good practice includes clean pumps and scoops, closed containers, using opened drums promptly and asking the supplier whether the 28% grade contains a preservative.
Shelf life
Published shelf lives for SLES typically range from about 12 to 24 months from production, in unopened original containers under recommended conditions. Stock older than the stated period is not necessarily unusable, but should be retested for active matter, pH and appearance before use. Rotate stock first in, first out.
Packing options
| Packing | Suits | Notes |
|---|---|---|
| Plastic drums (open-top for paste, closed-top for liquid) | Small and medium plants | Open-top drums make scooping or pumping paste easier |
| IBCs (around 1,000 L) | Medium to large plants, 28% liquid and paste | Bottom valve flows easily for liquid; paste may need a suitable pump or wide valve |
| Flexitanks | Large-volume users with tank storage | Usually for liquid; check unloading equipment |
| Bulk road tankers | Plants near the supply point | Heated or insulated tankers for paste in cold climates |
Receiving checklist
- Check that the lot numbers on the packs match the certificate of analysis.
- Inspect containers for damage, leaks, bulging or broken seals.
- Take a representative sample, mixing the contents first if layering is likely.
- Test active matter, pH and appearance against the specification before releasing to production.
- Record the receiving date and store under the conditions above.
Cool, closed and clean: the 70% paste tolerates storage well; the 28% liquid needs more care once opened.
Specifying packing and documents
State the grade, quantity, packing type and size, and any palletisation and labelling needs. Ask for the SDS, a CoA for each lot, the shelf life and storage conditions, and a certificate of origin if required. Nuroil supplies SLES 70% and 28% on request with a CoA for every delivery, on FOB, CFR or CIF terms. Use the quote form to send the details.
