Technical document

· PDF

Tell us who you are and the document downloads straight away. We use these details only to follow up on your requirement.

Samples & documents

What can we send you?

Tick what you need
Request a quote
Expert article3 min read6 sections

Knowledge centre · Industrial chemicals

SLES 70% or SLES 28%: which concentration to buy

SLES is traded as a 70% paste and a 28% liquid. How freight, handling, plant equipment and batch size decide which concentration makes sense.

Written by the Nuroil trade desk, Sharjah

On this page · 6 sections
  1. 01Why two concentrations exist
  2. 02The case for SLES 70%
  3. 03The case for SLES 28%
  4. 04Side by side
  5. 05A practical decision rule
  6. 06Comparing offers fairly

Sodium lauryl ether sulphate (SLES) is the workhorse anionic surfactant in shampoos, shower gels, hand washes and dishwashing liquids. It is traded mainly in two strengths: a concentrated paste of about 70% active matter and a pourable liquid of about 28%. The surfactant molecule is the same in both. The difference is water, and that difference has real consequences for cost, handling and plant design.

Why two concentrations exist

SLES does not dissolve in water in a simple, smooth way. As the concentration rises, the molecules pack into ordered structures and the mixture passes through very viscous gel phases. Producer data for a typical 2-mole ethoxylate show stable, liquid solutions up to about 28% active matter. Above about 30%, at intermediate concentrations, the material becomes a stiff gel that is very hard to pump. At around 70% it is a flowable paste again.

So the two commercial strengths sit on either side of the gel region: 28% is the strongest liquid that stays easy to handle, and 70% is the most concentrated paste that can still be pumped with the right equipment.

The case for SLES 70%

  • Freight: 70% paste carries about two and a half times as much active surfactant per tonne as 28% liquid. For export shipments, that means far fewer containers, drums and pallets for the same amount of surfactant.
  • Storage: less warehouse space and fewer packages to handle per tonne of active.
  • Formulation freedom: concentrated products and low-water formulations can only be made from the high-active paste.
  • Lower relative water content: less water means less opportunity for microbial growth in storage.

The trade-off is that 70% paste must be diluted correctly. Adding water the wrong way, or stopping part-way, can trap a batch in the gel phase. Plants need suitable pumps, mixers and a defined dilution procedure.

The case for SLES 28%

  • Simple handling: it pours and pumps like a thick liquid and can go straight into a mixing tank.
  • No dilution step: no risk of gelling during dilution and no need for high-shear equipment.
  • Suits small producers: workshops making hand wash or dishwashing liquid in small batches with simple stirrers often find it easier to use.

The trade-offs are freight cost per unit of active, more packaging, and more water in the drum, which can make an unpreserved product more vulnerable to microbial spoilage.

Side by side

FactorSLES 70%SLES 28%
Physical formFlowable paste, clear to yellowishViscous liquid
Active per tonne shippedAbout 700 kgAbout 280 kg
PumpingPositive-displacement pumps preferredStandard transfer pumps usually adequate
Plant needsDefined dilution method, often high-shear mixingSimple mixing tank
Best suited toMedium to large plants, export buyers, concentrated productsSmall plants, local repackers, simple formulations

A practical decision rule

If the plant has, or can install, a pump and mixer able to handle paste and a written dilution procedure, 70% almost always works out cheaper per kilogram of surfactant delivered, especially over long shipping distances. If batches are small, staff are few and equipment is basic, 28% removes a process step and a source of failed batches.

Some larger plants buy 70% and dilute it themselves to a 25 to 28% stock solution, which they then use across several products. That gives the freight saving of the paste and the handling ease of the liquid, provided dilution is done well.

Same molecule, different water content. Choose by freight distance, batch size and the equipment you have, not by price per tonne alone.

Comparing offers fairly

Because the two strengths carry different amounts of surfactant, compare quotations on the basis of active matter, not on the gross weight of product. Ask each supplier for the guaranteed active matter range, the degree of ethoxylation, the 1,4-dioxane limit and the packing, and request a certificate of analysis for each lot. Nuroil supplies SLES 70% and 28% on request; send your requirement through the quote form.

KEEP READING

More from the knowledge centre.

STILL HAVE A QUESTION?

Ask the people who trade it every day.

Our trade managers answer technical and commercial questions about grades, specifications, packing and shipping.

LET’S TALK ABOUT YOUR REQUIREMENTS

Your next shipment starts here.

Request a quote