Technical document

· PDF

Tell us who you are and the document downloads straight away. We use these details only to follow up on your requirement.

Samples & documents

What can we send you?

Tick what you need
Request a quote
Guide3 min read7 sections

Knowledge centre · Water & pool treatment

Handling, storage and packing of sodium bisulphate

Storing and handling sodium bisulphate: moisture and caking, keeping it apart from chlorine products, protective equipment, spills and packing.

Written by the Nuroil trade desk, Sharjah

On this page · 7 sections
  1. 01Hazards in brief
  2. 02Moisture and caking
  3. 03Segregation
  4. 04Personal protection
  5. 05Spills
  6. 06Packing options
  7. 07Specifying packing in an enquiry

Sodium bisulphate is often described as a safer alternative to liquid acids, and in many ways it is. But a dry acid still needs proper care in warehouses, plant rooms and blending halls. Most problems with this product come from two things: moisture and incompatible neighbours. This guide covers both, along with personal protection, spill response and packing.

Hazards in brief

  • Eyes: classified as causing serious eye damage. Dust or granules in the eye are the main injury risk.
  • Skin and airways: dust is irritating, and in contact with sweat or moisture becomes acidic on the skin or in the nose and throat.
  • Reactivity: dissolves to give strongly acidic solutions that neutralise bases with heat release, and react with hypochlorites and chlorinated isocyanurates to release chlorine gas.
  • Fire: non-flammable, but it should not be stored where it could be wetted together with oxidisers or chlorine products in a fire.

Always confirm the hazard and first-aid details in the supplier's SDS for the specific grade.

Moisture and caking

Anhydrous sodium bisulphate is hygroscopic. In humid air it absorbs water, the granules stick together and bags set into hard lumps. Damp product is also more corrosive to metal shelving, pallet racking and floors, because a film of acidic solution forms on its surface.

  • Store indoors in a dry, ventilated area, off the floor on pallets.
  • Keep bags and pails closed. Reseal opened bags immediately or transfer the contents to a lidded plastic container.
  • Avoid stacking so high that the bottom bags are compressed, which encourages caking.
  • Rotate stock first in, first out, and use opened packs promptly.
  • Do not store directly against walls that sweat or under roof leaks.

Segregation

The single most important storage rule is to keep sodium bisulphate apart from chlorine products such as calcium hypochlorite, sodium hypochlorite, TCCA and SDIC. A mixture of a hypochlorite with sodium bisulphate has been recorded to ignite and explode, and even a small amount of moisture bringing acid into contact with hypochlorite releases chlorine gas.

  • Use separate rooms, or at least separate bunded areas with physical barriers, for acids and chlorine products.
  • Keep it away from alkalis such as caustic soda and soda ash, and from cyanides, sulphides and nitrites, which release toxic gases with acids.
  • Use dedicated scoops and buckets, labelled for acid only.

Personal protection

TaskMinimum protection
Moving sealed bagsGloves, safety glasses, safety footwear
Opening bags, scooping, dosingChemical goggles, acid-resistant gloves, long sleeves
Emptying bulk bags, blending powdersGoggles or face shield, gloves, dust mask or respirator as the SDS specifies, local exhaust ventilation
Spill clean-upGoggles, gloves, boots, dust protection

Eye-wash facilities should be close to any area where the product is opened.

Spills

Sweep up dry spills carefully to avoid raising dust and place them in a clean, labelled plastic container for reuse or disposal. Do not use the same tools or containers that handle chlorine products. Flush small residues with plenty of water only where the run-off is controlled, since the solution is acidic. Large spills and disposal should follow the SDS and local rules.

Packing options

PackingTypical usersPoints to check
Small pails and tubsResidential pools, spas, retailTamper-evident lids, child-resistant closures if retailed
Multi-wall or woven bags with linerPool service companies, hotels, blendersMoisture-barrier liner, stacking height
Bulk bags (FIBCs) with linerFormulators, repackers, feed and litter treatmentLiner sealing, discharge spout, dry container stowage

For sea freight, palletised bags should be stretch-wrapped and loaded into clean, dry containers. Desiccants and kraft lining of the container help in humid transits.

Keep it dry, keep it closed, and keep it well away from chlorine. Those three rules prevent most incidents.

Specifying packing in an enquiry

State the pack size, liner requirement, palletisation, labelling language and any retail requirements, together with the grade and quantity. Ask for the SDS, a certificate of analysis for each lot and, if needed, a certificate of origin and third-party inspection. Nuroil supplies sodium bisulphate on request; use the quote form to send the details.

KEEP READING

More from the knowledge centre.

STILL HAVE A QUESTION?

Ask the people who trade it every day.

Our trade managers answer technical and commercial questions about grades, specifications, packing and shipping.

LET’S TALK ABOUT YOUR REQUIREMENTS

Your next shipment starts here.

Request a quote