Technical document

· PDF

Tell us who you are and the document downloads straight away. We use these details only to follow up on your requirement.

Samples & documents

What can we send you?

Tick what you need
Request a quote
Expert article3 min read6 sections

Knowledge centre · Industrial chemicals

How nitric acid is used to make nitrogen fertilizers

Why most nitric acid ends up in fertilizers: neutralisation to nitrates, the nitrophosphate route to NPK, and what acid quality fertilizer plants need.

Written by the Nuroil trade desk, Sharjah

On this page · 6 sections
  1. 01From ammonia to nitric acid
  2. 02Main fertilizer routes
  3. 03Why concentration matters to the buyer
  4. 04Quality points for fertilizer use
  5. 05Other agricultural uses
  6. 06Sourcing nitric acid for fertilizer production

Most of the world's nitric acid never leaves the site where it is made. It is produced next to ammonia and fertilizer plants and fed straight into the units that make nitrate fertilizers. Understanding that link explains why industrial nitric acid is usually sold at 55 to 68% strength, and what fertilizer producers look for when they buy acid from outside.

From ammonia to nitric acid

Industrial nitric acid is made by the Ostwald process. Ammonia is burned with air over a platinum-based catalyst to form nitric oxide. The nitric oxide is oxidised further to nitrogen dioxide, which is absorbed in water to give nitric acid. The result is a "weak" acid, typically somewhere in the 50 to 68% range depending on plant design and pressure. Nitric acid forms an azeotrope with water at about 68%, so ordinary distillation cannot concentrate it beyond that; the 68% grade is therefore the strongest common commercial product without extra processing.

Main fertilizer routes

01

Neutralisation with ammonia

The largest single use of nitric acid is reacting it with ammonia to make an ammonium nitrate solution. That solution is concentrated and then either granulated or prilled, or blended with other materials. Historically, three quarters or more of nitric acid production has gone into ammonium nitrate.
02

Calcium ammonium nitrate

Ammonium nitrate solution is mixed with finely ground limestone or dolomite and granulated. The carbonate filler gives a product with lower nitrogen content that is widely used on acidic soils.
03

Urea ammonium nitrate solutions

Ammonium nitrate solution is combined with urea solution to make liquid nitrogen fertilizers for fertigation and spraying.
04

The nitrophosphate route

Instead of using sulphuric acid to dissolve phosphate rock, some producers use nitric acid. The rock is digested to give a mixture of phosphoric acid and calcium nitrate. The liquor is chilled so that calcium nitrate crystallises and can be separated. The remaining acid is neutralised with ammonia and potassium salts may be added to make NPK fertilizers. The separated calcium nitrate can be sold as a fertilizer in its own right or converted to ammonium nitrate and calcium carbonate for calcium ammonium nitrate. The route avoids the large volumes of gypsum by-product that sulphuric acid digestion produces.

Why concentration matters to the buyer

  • Water balance. Every tonne of water that comes in with the acid must be evaporated later to produce solid fertilizer. Stronger acid reduces evaporation load and energy use.
  • Process design. Neutralisers and digesters are designed around a specific acid strength. Using a weaker or stronger acid than the design point changes heat release and may need adjustments to operation.
  • Freight. Buying stronger acid means shipping less water per tonne of nitrogen delivered.

Quality points for fertilizer use

Fertilizer users generally care most about concentration consistency and contaminants that affect their process. Chlorides are a particular concern because they can promote corrosion of stainless steel equipment and, in ammonium nitrate systems, they are undesirable impurities. Dissolved nitrogen oxides, which give acid a yellow colour, are usually limited because they are released as fumes during handling. Iron and other metals can indicate corrosion in the supply chain.

For a fertilizer plant, the right nitric acid is the one that matches the design strength of its neutraliser or digester, delivered consistently.

Other agricultural uses

Dilute nitric acid is also used in some irrigation systems to lower water pH, clean drip lines of mineral deposits and supply a small amount of nitrate nitrogen. This is done with careful dosing equipment and appropriate protective measures, following local agronomic advice.

Sourcing nitric acid for fertilizer production

When enquiring, state the concentration range your plant is designed for, the maximum chloride and dissolved nitrogen oxide content you can accept, monthly volume and whether you can receive bulk by ISO tank. Nuroil sources from established producers, issues a CoA with every delivery and can arrange inspection on request. Send your requirements through the quote request form.

KEEP READING

More from the Knowledge Centre.

STILL HAVE A QUESTION?

Ask the people who trade it every day.

Our trade managers answer technical and commercial questions about grades, specifications, packing and shipping.

LET’S TALK ABOUT YOUR REQUIREMENTS

Your next shipment starts here.

Request a quote