Food-grade phosphoric acid is the same molecule as the technical acid used in metal treatment, but it is made and tested to a much tighter purity standard. Food and beverage plants use it in two quite different roles: as an ingredient, listed as E338, and as a processing chemical for cleaning equipment. This article explains both, and what makes the grade suitable for food contact.
As an ingredient: acidulant and pH control
The best-known use is in cola-type soft drinks, where phosphoric acid provides a sharp, clean sourness that differs from the fruitier taste of citric acid. It is also used as an acidulant in jams and some processed foods, and to adjust pH in products where a precise acidity is needed for flavour, setting or microbial stability.
Compared with organic acids, phosphoric acid is strong for its cost and adds little flavour of its own beyond acidity. It is supplied concentrated, usually at 75% or 85%, and dosed in very small proportions after dilution. Food-grade acid is also the starting material for many food phosphate salts, such as sodium and calcium phosphates used as leavening agents, emulsifying salts and nutrient sources.
As a processing chemical: acid cleaning
In dairies, breweries and beverage plants, phosphoric acid is a common base for acid cleaners used in clean-in-place (CIP) systems. The typical cycle is an alkaline wash to remove fat and protein, followed by an acid wash to dissolve mineral deposits. In dairies these deposits are often called milk stone, a build-up of calcium phosphate and protein on heat exchangers and tanks. Phosphoric acid is also used in some acid sanitiser formulations.
- It removes hard-water scale and mineral films that alkaline cleaners leave behind.
- It is less aggressive towards stainless steel than hydrochloric acid, which is one reason it is preferred for food plant equipment.
- It is often blended with other acids or surfactants by cleaning-chemical formulators rather than used neat.
What makes it food grade
Phosphoric acid can be made two ways. The thermal route burns elemental phosphorus and produces a very pure acid. The wet route digests phosphate rock with sulphuric acid and produces an impure acid that must then be purified, usually by solvent extraction followed by steps to remove fluoride, arsenic and heavy metals. Purified wet-process acid now supplies most of the technical and food-grade market, and both routes can meet food specifications.
Food-grade acid is tested against a recognised monograph, such as the Food Chemicals Codex or the specification set by the regulator in the destination market. These set limits on arsenic, lead, cadmium, fluoride and other impurities that technical grade does not tightly control. Separate national standards for technical and food-grade phosphoric acid exist in several countries, which reflects how different the two products are in practice.
The difference between food and technical grade is not the acid itself but the limits on what comes with it: arsenic, lead, fluoride and other trace impurities.
Handling in a food plant
Concentrated food-grade acid is just as corrosive as technical acid. It needs the same eye and skin protection, eyewash stations and careful dilution, always adding acid to water. Food plants should store it apart from technical chemicals, use dedicated transfer equipment, and keep the original batch labels and certificates for traceability. Never mix acid cleaners with chlorine-based sanitisers, because acids release chlorine gas from hypochlorite. Refer to the supplier's safety data sheet for full handling advice.
What to ask for when buying food-grade acid
- Concentration (75% or 85%) and the monograph the product meets, such as FCC or the local food additive standard.
- A certificate of analysis per batch showing the impurity limits, not just assay.
- Any halal, kosher or food-safety documentation your customers or auditors require, confirmed in advance.
- Packing suitable for food use, such as new HDPE drums or IBCs with tamper-evident closures.
Nuroil supplies phosphoric acid on request, including food grade, with a CoA on every delivery and the MSDS and certificate of origin on request. To discuss a requirement, contact us or use the quote request form.
