Technical document

· PDF

Tell us who you are and the document downloads straight away. We use these details only to follow up on your requirement.

Samples & documents

What can we send you?

Tick what you need
Request a quote
Guide3 min read6 sections

Knowledge centre · Industrial chemicals

Transport classification of anhydrous ammonia (UN 1005)

3 with subsidiary class 8, labels, packaging and emergency information.

Written by the Nuroil trade desk, Sharjah

On this page · 6 sections
  1. 01The basic classification
  2. 02Classification by mode
  3. 03Packaging and tanks
  4. 04Emergency response information
  5. 05Documents for a shipment
  6. 06Arranging supply

Anhydrous ammonia is one of the most widely transported hazardous gases. Everyone involved in a shipment, from the supplier to the receiving refrigeration plant, needs to recognise its classification and what it means for packaging, labelling and emergency response. This guide summarises the main points. Always confirm details against the current edition of the regulations for each mode of transport and the product SDS.

The basic classification

  • UN number: UN 1005
  • Proper shipping name: AMMONIA, ANHYDROUS
  • Class: 2 (gases), division 2.3 (toxic gas)
  • Subsidiary hazard: 8 (corrosive)
  • Labels: 2.3 toxic gas label plus 8 corrosive label

Under the UN model regulations and the international codes derived from them, anhydrous ammonia is classed as a toxic gas with a corrosive subsidiary hazard. Some national domestic rules historically classed it as a non-flammable gas (2.2) with an inhalation hazard marking; several have since aligned with the 2.3 classification, but local rules should be checked for domestic legs. Although ammonia can burn at high concentrations, it is not classed as a flammable gas for transport.

Classification by mode

ModeGoverning rulesPoints to note
SeaIMDG CodeClass 2.3, subsidiary 8; stowage and segregation requirements for toxic gases
Road (Europe and many other regions)ADRHazard identification number 268 on orange plates; portable tank instruction T50
RailRID or national rail rulesTank car requirements for toxic gases
AirICAO / IATAToxic gases are heavily restricted or forbidden by air; check the current rules before considering it

The hazard identification number 268 used on road tanks combines 2 (gas), 6 (toxic) and 8 (corrosive). It appears above the UN number on orange plates.

Packaging and tanks

Anhydrous ammonia is transported as a liquefied gas under pressure. Approved packagings include cylinders, pressure drums and ton containers, portable tanks (ISO tanks) and road and rail tank vehicles, all designed and periodically tested for the pressure. Portable tanks for UN 1005 follow tank instruction T50 for liquefied gases, which sets design pressure and maximum filling ratio. Filling limits are important because liquid ammonia expands significantly as it warms; an overfilled container can become liquid-full and fail.

  • Cylinders and tanks must be within their test date.
  • Valves must be protected during transport, with caps or guards as required.
  • Containers should be dedicated to ammonia service, which also protects purity.

Emergency response information

The widely used Emergency Response Guidebook assigns ammonia, anhydrous to guide 125 (gases, toxic and/or corrosive). For a small spill it recommends initial isolation of about 30 metres in all directions; for large spills from tankers or rail cars, isolation and downwind protective distances are much larger and depend on container type, wind and time of day. Ammonia gas is lighter than air when dry, but cold vapour clouds from a liquid release can stay low and drift along the ground.

Drivers and receiving staff should know where the emergency information is kept, how to contact the emergency number on the documents, and the site's own emergency action plan. Responders need breathing apparatus and chemical protective clothing suited to ammonia; untrained people should move upwind and away rather than attempt to intervene.

Transport documents, labels and placards for ammonia must all agree. A mismatch can stop a shipment at a port or border.

Documents for a shipment

  • Dangerous goods declaration showing UN 1005, the proper shipping name, class 2.3 and subsidiary 8.
  • Container or tank certificates showing test dates.
  • Safety data sheet and emergency response information for the carrier.
  • Certificate of analysis for the lot, and certificate of origin where required.

Arranging supply

When enquiring, state the container type, quantity, grade and destination, and whether you need delivery to site or collection at port. Nuroil supplies on FOB, CFR or CIF terms, provides a CoA with every delivery, and can arrange SDS and inspection on request. Contact us through the quote request form.

KEEP READING

More from the knowledge centre.

STILL HAVE A QUESTION?

Ask the people who trade it every day.

Our trade managers answer technical and commercial questions about grades, specifications, packing and shipping.

LET’S TALK ABOUT YOUR REQUIREMENTS

Your next shipment starts here.

Request a quote