Cutback bitumen is a liquid that contains a flammable solvent, so it cannot be packed and shipped in the same way as solid paving bitumen in bags or cooled drums. Packing has to keep the solvent in, stop leaks, and meet dangerous goods rules where they apply. This guide covers the common options and the paperwork buyers should expect.
Packing options
| Packing | Typical use | Points to watch |
|---|---|---|
| Closed-head steel drums (about 200 litres) | Small projects, remote sites, primers and patching grades | Sound seals and bungs, upright stowage, no dents; product cannot be heated in the drum with an open flame |
| Bulk road tankers | Domestic delivery to sprayers and depots | Clean, dry tanks; temperature control; earthing during transfer |
| ISO tank containers | Export of larger volumes | Heating coils if heavier grades must be warmed; tank cleaning certificate; correct marking |
One safety data sheet for a rapid curing cutback recommends stainless steel for containers and linings, and advises against PVC and polyethylene. Follow the supplier's guidance for the grade concerned, especially for lighter solvents.
Dangerous goods classification
Cutbacks are often classed for transport under the entry for liquid tars, which covers road oils and cutback bitumens, with UN number 1999. A producer's safety data sheet for RC-250 lists UN 1999 with packing group III. The exact class and packing group depend on the product's flash point and the transport mode, so the shipper must classify each grade from its own safety data sheet. Heavier grades with high flash points may fall outside some rules, while light RC grades are clearly flammable liquids.
Correct classification affects which ships and terminals will accept the cargo, how containers are labelled and stowed, and the declaration that accompanies the shipment.
Protecting quality in transit
- Keep containers closed: solvent loss raises viscosity and can move the product out of grade.
- Avoid water ingress: specifications limit water content and require that the product does not foam when heated.
- Avoid prolonged heat: stow drums away from heat sources and out of direct sun where possible.
- Open hatches and bungs with care: solvent vapour and hydrogen sulphide can build up in the headspace.
For export cargoes, agree in advance who is responsible for the dangerous goods declaration and whether the receiving terminal has any extra rules for flammable liquids.
Storage on arrival
Store drums upright in a ventilated, shaded area away from ignition sources, with spill containment, and keep them away from drains and stormwater. Bulk tanks should be kept at or below the supplier's maximum storage temperature; for Australian AMC grades this ranges from about 100°C for the thinnest primer to about 185°C for the heaviest seal grade, for storage periods of up to 24 hours. Use older stock first and reseal part-used drums.
Documents to request
- Certificate of analysis for the shipped lot: viscosity, flash point, water, distillation and residue tests.
- Safety data sheet for the exact grade, in a language usable on site.
- Dangerous goods declaration and correct marking where the cargo is regulated.
- Packing list and weight certificate, giving drum count, net and gross weights.
- Certificate of origin and independent inspection report where the buyer or importing authority requires them.
For cutbacks, the safety data sheet and flash point decide how the cargo can be packed, labelled and shipped.
Making an enquiry
State the grade and specification, the quantity, preferred packing, destination port and Incoterm. Mention any limits at the receiving site, such as no heating facilities or restricted access for tankers, so the most practical packing can be proposed. Nuroil supplies on FOB, CFR or CIF terms, includes a certificate of analysis with each delivery, and provides the other documents on request. Use the quote request form or the cutback bitumen page.


