Technical document

· PDF

Tell us who you are and the document downloads straight away. We use these details only to follow up on your requirement.

Samples & documents

What can we send you?

Tick what you need
Request a quote
Expert article3 min read6 sections

Knowledge centre · Water & pool treatment

Preparing and dosing a calcium hypochlorite stock solution

How to make a calcium hypochlorite stock solution of known strength, deal with the insoluble residue, and dose it reliably by pump or by hand.

Written by the Nuroil trade desk, Sharjah

On this page · 6 sections
  1. 01Calculating the strength
  2. 02Mixing step by step
  3. 03Dosing pumps and injection points
  4. 04How long a stock solution lasts
  5. 05Safety
  6. 06Specifying product for stock-solution use

Granular calcium hypochlorite is often used by first making a stock solution, which is then dosed by a metering pump or measured by hand into tanks, pools or small water systems. A well-made stock solution has a known strength, is free of sediment that blocks pumps and is used before it weakens. This article covers the practical steps.

Calculating the strength

The strength of the stock depends on the available chlorine of the product, which is commonly 65 to 70%. To make a solution containing a target amount of chlorine, divide the chlorine needed by the available chlorine fraction.

Target stock strengthChlorine per litreProduct at 70%Product at 65%
0.5%5 gabout 7.1 gabout 7.7 g
1%10 gabout 14.3 gabout 15.4 g
2%20 gabout 28.6 gabout 30.8 g

The dosing rate then follows from the stock strength. For example, 1 L of a 1% stock contains 10 g of chlorine and adds 1 mg/L to 10,000 L of water before any chlorine demand is satisfied. Use the available chlorine from the certificate of analysis for the batch, and allow for some loss if the product is old.

Mixing step by step

  1. Use a clean, dedicated plastic container and clean water. Fill it with most of the water first.
  2. Weigh the granules on a dedicated scale; do not estimate with household spoons for system dosing.
  3. Add the granules to the water, never water onto the granules, and stir gently with a clean non-metal paddle.
  4. Let the solution stand so the insoluble residue settles, then draw off or decant the clear liquid into the dosing tank.
  5. Label the tank with the strength and the date and time it was made.

Commercial calcium hypochlorite contains a small proportion of insoluble matter, including calcium compounds. Settled residue should be kept out of pumps and injectors and disposed of as the safety data sheet directs.

Dosing pumps and injection points

  • Use a foot valve strainer set above the tank floor so the pump draws clear liquid, not sediment.
  • Expect scale at the injection point. Calcium hypochlorite solution is alkaline and contains calcium; where it meets hard or alkaline water, calcium carbonate can deposit and block the injector. Regular inspection and cleaning are part of normal maintenance.
  • Use pump materials suited to hypochlorite. Calcium hypochlorite attacks many metals and some plastics, so check compatibility with the pump maker.
  • Keep the dosing line dedicated. Never use the same pump, tank or line for acids or other chlorine products.

How long a stock solution lasts

Dry calcium hypochlorite is relatively stable, but once dissolved the chlorine begins to decline. Patent data on decomposition of calcium hypochlorite in water show the rate roughly doubles with each 10 °C rise in temperature, so heat makes a big difference. Good practice is to make only what will be used within a short period, keep the tank covered and out of sunlight, and check the strength of the stock with a test kit if it has been standing. In warm climates, daily preparation is common.

Safety

  • Wear eye protection, chemical-resistant gloves and protective clothing when handling granules and stock.
  • Mix in a ventilated area; dust and solution irritate the eyes, skin and lungs.
  • Never add acids, ammonia, fertilizers, TCCA or other chlorine products to calcium hypochlorite or its solution; dangerous reactions and toxic gas can result.
  • Keep granules sealed and dry; contamination with small amounts of water or organic material can lead to heating and fire.
Weigh the product, settle the residue, label the tank and make it fresh: those four habits keep stock-solution dosing accurate.

Specifying product for stock-solution use

For stock solutions, granules are usually preferred over tablets because they dissolve quickly. Ask for available chlorine and insoluble matter on the certificate of analysis, a product approved for drinking water where relevant, and packing that can be resealed between uses. Nuroil supplies calcium hypochlorite granules on request; send quantities and destination via the request a quote page.

KEEP READING

More from the Knowledge Centre.

STILL HAVE A QUESTION?

Ask the people who trade it every day.

Our trade managers answer technical and commercial questions about grades, specifications, packing and shipping.

LET’S TALK ABOUT YOUR REQUIREMENTS

Your next shipment starts here.

Request a quote