Technical document

· PDF

Tell us who you are and the document downloads straight away. We use these details only to follow up on your requirement.

Samples & documents

What can we send you?

Tick what you need
Request a quote
Guide3 min read7 sections

Knowledge centre · Water & pool treatment

Calcium hypochlorite 65% and 70% grades: what the difference means

What separates 65% and 70% calcium hypochlorite, how the grade changes dose and cost per kilogram of chlorine, and what else to compare.

Written by the Nuroil trade desk, Sharjah

On this page · 7 sections
  1. 01What the percentage measures
  2. 02Effect on dosing
  3. 03Beyond the headline figure
  4. 04Which grade for which job
  5. 05Standards that apply
  6. 06Safety is the same for both grades
  7. 07What to put in an enquiry

Calcium hypochlorite is traded mainly in two strengths, around 65% and around 70% available chlorine. The difference looks small, but it affects how much product is needed, how offers should be compared and, together with the water content of the product, how it is classified and handled. This guide explains what the grade figure means and how to use it.

What the percentage measures

The percentage is available chlorine: the oxidising power of the product expressed as an equivalent weight of chlorine. Pure calcium hypochlorite would be close to 100% on this scale, so a commercial product at 65 or 70% also contains water of hydration, sodium chloride and other calcium salts left from manufacture, plus a small amount of insoluble matter. Higher-strength grades contain proportionally less of these.

Effect on dosing

Because dose is set by the chlorine needed, the weaker grade requires more product for the same result. The table shows the product needed to supply 100 g of chlorine, which raises the chlorine in 100 m3 of water by 1 mg/L before demand.

ProductAvailable chlorineProduct for 100 g chlorineRelative quantity
Calcium hypochlorite65%about 154 gabout 108%
Calcium hypochlorite70%about 143 g100%
TCCA, for reference90%about 111 gabout 78%

A 65% grade therefore needs roughly 8% more product by weight than a 70% grade for the same chlorine. When comparing offers, convert each to cost per kilogram of available chlorine delivered, including freight and packing, rather than comparing cost per kilogram of product.

Beyond the headline figure

Two products with the same stated strength can still behave differently. Points worth comparing:

  • Minimum or typical: is 70% a guaranteed minimum at packing, or a typical value? Specifications for water treatment often state a minimum at time of manufacture.
  • Insoluble matter: more insolubles mean more sediment in stock solutions and more residue in feeders and pools.
  • Water content: hydrated grades are made with a controlled water content, which affects stability and transport classification.
  • Particle size: granule size affects dissolving speed and dust.
  • Form: granules for solutions and shock dosing, tablets for purpose-designed calcium hypochlorite feeders.

Which grade for which job

UseConsiderations
Pool shock and routine dosingEither grade; dose by available chlorine and watch calcium hardness
Feeder tabletsGrade and tablet size specified by the feeder maker
Drinking water and well disinfectionProduct meeting the applicable drinking-water standard, such as AWWA B300 or national approval
Long supply chains and hot storageFavour a well-packed product with a clear stated minimum; plan for some loss over time

Standards that apply

European standard EN 15796 covers calcium hypochlorite for swimming pool water treatment, including characteristics, test methods and safe handling, while AWWA B300 covers hypochlorites, including calcium hypochlorite, for water, wastewater and reclaimed water treatment. Buyers in regulated sectors often cite one of these or a national equivalent in the purchase specification.

Compare calcium hypochlorite offers by the cost of available chlorine, not by the cost of product, and check what the strength figure actually guarantees.

Safety is the same for both grades

Both grades are strong oxidisers and corrosive. They decompose with acids, releasing chlorine, react violently with ammonia, amines and combustible materials, and must never be mixed with TCCA or other chlorine products. Store them dry, cool and segregated, and follow the safety data sheet.

What to put in an enquiry

State the grade (65% or 70%), whether the figure is a minimum, form and granule size or tablet weight, any standard required, packing, quantity and destination. Ask for the certificate of analysis showing available chlorine and insolubles, and the safety data sheet. Nuroil supplies both grades on request; use the quote request form to send your specification.

KEEP READING

More from the knowledge centre.

STILL HAVE A QUESTION?

Ask the people who trade it every day.

Our trade managers answer technical and commercial questions about grades, specifications, packing and shipping.

LET’S TALK ABOUT YOUR REQUIREMENTS

Your next shipment starts here.

Request a quote