SLES, sodium lauryl ether sulphate or sodium laureth sulphate, is an anionic surfactant made from C12–14 fatty alcohol that has been ethoxylated, usually with about 2 mol of ethylene oxide, then sulphated and neutralised. It foams well, thickens easily with salt and is milder on skin than sodium lauryl sulphate.
It is traded as a 70% active paste, which carries the least water per tonne of surfactant, and as a 28% liquid that is ready to blend. Between about 30% and 60% active it forms a stiff gel, so the paste is diluted by adding it to water with stirring.
Identity
Formula
C₁₂H₂₅(OCH₂CH₂)₂OSO₃Na
Molar mass
About 376 g/mol
CAS
68585-34-2
Sodium lauryl ether sulphateWhy SLES
Steady active contentActive matter within a narrow band, so foam and thickness stay the same from batch to batch.
Paste or liquid70% paste to save freight on active matter; 28% liquid to blend without dilution.
Low 1,4-dioxaneDioxane is reported on the batch certificate; lower-dioxane grades are offered on request.
Documented qualityEach offered batch comes with its Certificate of Analysis and safety data sheet.
What Nuroil does on every order
Why choose SLES from Nuroil?
Checked against the batch CoA
Active matter, unsulphated matter, sodium sulphate, pH and dioxane are reviewed before loading.
Grade matched to your use
70% or 28%, and the colour and dioxane limits your formulation needs.
Packed for the climate
Sealed drums, IBCs or bulk, kept out of the sun in transit and at the port.
One desk, firm offers
FOB, CFR or CIF from our Sharjah trade desk, usually within 24 hours.
02 TECHNICAL DATA
Technical specification.
Active matter, 70% grade
68–72%Two-phase titration (ISO 2271)
Active matter, 28% grade
27–29%Two-phase titration (ISO 2271)
Unsulphated matter (70% grade)
2.5–3.5% maxSolvent extraction
Sodium sulphate (70% grade)
1.0–1.5% maxTitration
pH (1–5% solution)
7.0–9.5pH meter
1,4-Dioxane
20–50 ppm max, by producerGC
Ethoxylation
About 2 mol EO (3EO on request)Producer data
Appearance
70%: white to pale-yellow paste; 28%: clear to slightly hazy liquidVisual
01SLES 70%
Concentrated paste
The standard export grade: the least water per tonne of surfactant, for plants that dilute on site.
02SLES 28%
Ready to blend
A pumpable liquid that goes straight into the mix, for smaller plants without dilution equipment.
Selection guidance Tell us the product you make, your mixing equipment and any dioxane or colour limit, and we will confirm the grade.
The same surfactant at two strengths. The right one depends on how you mix.
Property
SLES 70%This page
SLES 28%
Active matter
68–72%
27–29%
Water shipped per tonne of active
Least
About 2.5 times more
Viscosity
Thick paste
Pourable liquid
Dilution
Paste into water with stirring
None, ready to blend
Best suited to
Larger plants that dilute on site
Smaller plants and direct blending
03 HOW IT IS MADE
From fatty alcohol to surfactant paste.
C12–14 fatty alcohol, from palm kernel or coconut oil or from petrochemical feedstock, is ethoxylated with ethylene oxide, sulphated with sulphur trioxide in a film reactor and neutralised with caustic soda to a 70% paste. Part of it is diluted to 28%.
01
Fatty alcohol and EO
C12–14 fatty alcohol reacted with about 2 mol of ethylene oxide.
02
Sulphation
The ethoxylate is sulphated with sulphur trioxide in a falling-film reactor.
03
Neutralisation
Caustic soda neutralises the acid to a 70% paste, diluted to 28% where needed.
04
Testing and packing
Each batch is tested for active matter, pH and dioxane, then packed.
04 APPLICATIONS
Where it foams.
01
Shampoo and body wash
The main foaming surfactant, often with betaine for mildness.
02
Liquid hand soap
Rich foam that thickens with salt.
03
Dishwashing liquids
Foam and grease removal, usually alongside LABSA.
04
Liquid laundry detergents
Co-surfactant for cleaning and hard-water tolerance.
05
Household cleaners
Surface, floor and multi-purpose cleaners.
06
Industrial cleaning
Car-wash products and industrial detergents.
05 SAFETY & HANDLING
A surfactant. Protect your eyes.
This summary does not replace the Safety Data Sheet. Review the SDS and site procedure before first handling.
Danger
H315 Causes skin irritation.
H318 Causes serious eye damage.
H412 Harmful to aquatic life with long lasting effects.
UN
Not regulated
Transport
Not dangerous goods
01
Protect your eyes
The 70% paste can cause serious eye damage; wear eye protection and gloves.
02
Avoid skin contact
The concentrate irritates skin; wash off splashes with water.
03
Paste into water
Add the paste to water with stirring, never water to the paste, to pass through the gel stage.
04
Keep spills out of drains
Contain and collect spills; the concentrate is harmful to aquatic life.
05
Exposure response
Rinse eyes cautiously with water for several minutes, remove contact lenses, and seek medical attention.
Sealed, shaded and not too hot.
StoreSealed, shaded
Heat and acidic conditions slowly hydrolyse SLES, and the dilute liquid can grow bacteria once opened. Kept sealed and shaded it is commonly used within a year; confirm the producer’s shelf life with the offer.
Keep containers closedReseal drums and IBCs to keep out dirt and bacteria and to stop the paste skinning.
Out of the heatShaded and ventilated, away from direct sun; avoid freezing the 28% liquid.
Apart from acidsAcids hydrolyse the surfactant; keep it from acids and strong oxidisers.
First in, first outUse the oldest stock first and keep the batch label with each lot.
Plan documentation early.
HS code3402.39
CAS number68585-34-2
TransportNot regulated
GHS
70%: skin irritation, serious eye damage, harmful to aquatic life; 28%: usually skin and eye irritation; confirm per SDS
Transport
Not dangerous goods by road, sea or air
Cosmetic use
Some markets limit 1,4-dioxane in finished products; confirm the limit for your market
National regulations
Confirm the destination’s chemical-import requirements
06 PACKING OPTIONS
Choose your packing.
Pack sizes and container loads depend on the producer and grade; the offer confirms them.
Small quantities
Plastic drums
Sealed drums of paste or liquid, the usual packing for formulators.
SLES is ethoxylated before sulphation, SLS is not. The ethoxylation makes SLES milder on skin, more tolerant of hard water and easier to thicken with salt.
02What does 2EO mean?
The average number of moles of ethylene oxide added to each mole of fatty alcohol. 2EO is the common grade; 3EO is a little milder.
03Should I buy 70% or 28%?
70% carries far less water per tonne of surfactant, so it costs less to ship, but it must be diluted with care. 28% is ready to blend.
04How do I dilute the 70% paste?
Add the paste slowly to water with good stirring. Between about 30% and 60% active SLES forms a stiff gel, so never add water to the paste.
05What is the HS code?
SLES is an anionic surface-active agent, generally classified under HS 3402.39. CAS 68585-34-2 is the common identity; 68891-38-3 is also used.
06Is SLES dangerous goods?
No. It is not regulated for road, sea or air transport, though the 70% paste is classed for serious eye damage under GHS.
07What documents come with a shipment?
A Certificate of Analysis and Safety Data Sheet, with the Certificate of Origin as required.
Include the grade (70% or 28%), any dioxane or colour limit, quantity and destination for a tailored offer. We reply with a firm FOB, CFR or CIF offer, usually within 24 hours.