Every oil gets thinner as it warms up and thicker as it cools. Viscosity index, usually shortened to VI, is a single number that describes how strongly that happens. A higher VI means the oil's viscosity changes less across a temperature range. It is one of the first numbers on any base oil certificate and one of the properties that defines the API base oil groups.
How viscosity index is calculated
VI is not measured directly. It is calculated, under ASTM D2270 (or the equivalent ISO 2909), from two kinematic viscosity measurements made on the same oil:
- kinematic viscosity at 40 °C, and
- kinematic viscosity at 100 °C.
Both are measured by standard methods such as ASTM D445. The calculation then compares the oil with two reference oils that have the same viscosity at 100 °C. One reference oil was assigned a VI of 0 and thins a lot with temperature; the other was assigned a VI of 100 and thins much less. Where the sample's 40 °C viscosity falls between the two references sets its VI. Oils that perform better than the VI 100 reference get values above 100, using a separate formula.
The method does not apply to very light products with a viscosity below 2 mm²/s at 100 °C.
Typical values by base oil group
| Base oil type | Viscosity index | Comment |
|---|---|---|
| Group I (solvent refined) | 80 to 120 by definition; commonly around 90 to 105 | Typical SN150 and SN500 grades sit in the 90s. |
| Group II (hydroprocessed) | 80 to 120 | Often at the upper end of the range. |
| Group III (severely hydrocracked) | 120 and above | High VI is the defining feature. |
| Group IV (PAO) | Typically above 120 | Synthetic, wide temperature range. |
The group limits come from the API base oil categories; see Group I and Group III for more detail.
Why a higher VI is useful
Machines rarely run at one temperature. An engine starts cold and runs hot; a hydraulic system outdoors may see a wide daily swing. A lubricant has to be thin enough to circulate at the low end and thick enough to keep a protective film at the high end. The flatter the viscosity-temperature curve, the easier that is.
- Multigrade engine oils rely on high-VI base oils to meet both the cold and hot viscosity limits of a grade such as 5W-30 with less viscosity modifier.
- Hydraulic and industrial oils used outdoors benefit from more stable viscosity across seasons.
- Base oil quality. A higher VI generally reflects more paraffinic, more saturated molecules and more severe refining.
What VI does not tell you
VI is a useful screening number, but it has limits:
- It says nothing about low-temperature flow; pour point and cold-cranking tests cover that.
- It does not measure oxidation stability, volatility or additive solubility.
- For finished oils containing polymer viscosity modifiers, researchers have shown that VI can be misleading, and some prefer other measures of viscosity-temperature behaviour.
- Two oils with the same VI but different viscosity grades behave very differently in a machine. VI describes the shape of the curve, not the thickness.
Read VI together with the kinematic viscosities it was calculated from. The 40 °C and 100 °C figures tell you the grade; VI tells you how the oil moves between them.
Using VI in a base oil specification
Buyers normally set VI as a minimum, alongside a range for kinematic viscosity at 40 °C (and often at 100 °C), naming ASTM D2270 as the method. Check the certificate of analysis for each lot rather than a generic data sheet, because VI can vary slightly between batches and producing refineries.
Nuroil provides a CoA with every base oil delivery. Our base oil page lists the grades we supply.



