A drum of trichloroisocyanuric acid (TCCA) tablets should open to find hard, white, separate tablets of even size. When buyers instead find dust, broken pieces, tablets fused together or a strong chlorine smell, the cause usually lies in moisture, heat or handling somewhere between the press and the pool. Uneven dissolving in the feeder has its own set of causes. This article works through the most common complaints.
Tablets that crumble or arrive broken
Pressed tablets are strong in compression but can chip at the edges when drums are dropped or thrown. Some breakage is normal in long journeys, which is why tablet specifications often state a limit on fines or broken tablets. Excessive breakage usually points to one of three things:
- Rough handling: drums dropped from vehicles or stacked without pallets.
- Low tablet hardness: tablets pressed with too little force or from poorly graded granules are weaker and wear quickly.
- Moisture attack: TCCA is moisture sensitive. Damp air reaching the tablets softens the surface so tablets abrade against each other.
Broken pieces are still TCCA and can be used where the feeder accepts them, but fines dissolve much faster than whole tablets and can give a short burst of high chlorine.
Tablets that cake, swell or smell strongly
Tablets stuck together, swollen or yellowish, or a drum that releases a strong chlorine odour on opening, are signs that water has entered the pack. Safety data for TCCA notes that small amounts of water can react with it to release chlorine and nitrogen trichloride, an unstable and hazardous compound. Moisture also gradually lowers the available chlorine.
Treat such a drum with caution:
- Open it outdoors or in a well-ventilated area, standing upwind and wearing the protective equipment listed in the safety data sheet.
- Do not reseal a drum that is visibly reacting or hot, and do not add water to it.
- Never combine the contents with other chlorine products or place them in a container that held another chemical.
- Contact the supplier and follow the safety data sheet for disposal; do not tip the material into drains.
Tablets that dissolve unevenly in the feeder
In an erosion chlorinator, output depends on how much water flows over the tablets. Several problems are common:
| Symptom | Likely cause | What to check |
|---|---|---|
| Chamber full but chlorine falling | Bridging: tablets held up by an eroded crust | Flow setting; break up the crust following the feeder instructions |
| Chlorine spikes after a refill | Fines and broken tablets dissolving quickly | Tablet condition; avoid emptying dust from the drum bottom into the feeder |
| Output varies day to day | Changing water level or random tablet stacking | Feeder design and tablet size match |
| Tablets lasting far longer than expected | Low flow or very hard, dense tablets | Valve setting; tablet specification |
Patent literature on tablet chlorinators describes the bridging effect at very low flow rates, where the outside of the tablets erodes away and leaves a shell of residual material holding the column above the water. Raising flow modestly and loading tablets of the size the feeder was designed for usually restores steady output.
Preventing the problems
- Keep drums tightly closed between uses and replace the lid immediately after taking tablets.
- Store in a cool, dry, ventilated area away from sunlight, and off the floor where water could collect.
- Use clean, dry, dedicated scoops or gloves; never a wet or contaminated tool.
- Rotate stock so older drums are used first.
- Do not leave part-used drums open near pool water, hoses or wash-down areas.
Most crumbling, caking and odour complaints trace back to moisture. A drum that stays sealed and dry usually stays in specification.
Raising a quality complaint
If tablets arrive damaged, photograph the drums and their seals before opening further, keep the batch number and take a sealed sample for testing. Compare the certificate of analysis for available chlorine and tablet weight with your own results. When ordering, ask for tablet weight tolerance, hardness or breakage limits where available, and packing with intact moisture-resistant liners. Nuroil provides a certificate of analysis with every delivery and can arrange third-party inspection on request; contact us through the contact page.
