Pool chlorine products fall into two families. Stabilised chlorine, such as trichloroisocyanuric acid (TCCA) and sodium dichloroisocyanurate, carries cyanuric acid with it. Unstabilised chlorine, such as calcium hypochlorite, sodium hypochlorite and chlorine gas, does not. Choosing between them comes down to how cyanuric acid behaves in the water.
What cyanuric acid does
Ultraviolet light in sunshine breaks down free chlorine quickly. In an unstabilised outdoor pool on a bright day, a large part of the chlorine can be lost within hours. Cyanuric acid, often called stabiliser or CYA, binds loosely with chlorine and shields it from UV. The bound chlorine is released back into the water as the free chlorine is used up, so the pool holds its residual far longer.
The same binding is the drawback. Chlorine held by cyanuric acid is not available to disinfect, so the more cyanuric acid there is relative to free chlorine, the slower the water kills microorganisms. Studies of chlorine-resistant parasites such as Cryptosporidium have shown that even modest cyanuric acid levels greatly lengthen the time needed to inactivate them during remedial superchlorination.
How stabiliser builds up
Cyanuric acid is not consumed when chlorine does its work. It leaves the pool only with water lost through backwashing, splash-out, leaks and draining. A pool dosed only with TCCA therefore accumulates stabiliser steadily. From the molecular weights, every 1 ppm of free chlorine supplied by TCCA adds roughly 0.6 ppm of cyanuric acid. Over a season, that can take a pool well beyond the level where stabiliser is helpful.
For this reason pool codes limit it. The CDC's Model Aquatic Health Code treats a cyanuric acid to free chlorine ratio above 45 to 1 as a hazard calling for correction, and its latest edition requires immediate remediation once cyanuric acid reaches 300 ppm. Some researchers argue for tighter ratios. Local codes vary, and many do not allow stabiliser in indoor pools at all.
| Stabilised (TCCA, dichlor) | Unstabilised (calcium hypochlorite, sodium hypochlorite) | |
|---|---|---|
| Sunlight protection | Yes, through cyanuric acid | None |
| Speed of disinfection at the same free chlorine | Slower as cyanuric acid rises | Faster |
| Effect on pH | TCCA lowers pH; dichlor is close to neutral | Raises pH |
| Builds up in water | Cyanuric acid accumulates | Calcium (cal hypo) or salt (sodium hypo) accumulates |
| Typical use | Outdoor residential and resort pools; tablet feeders | Indoor and public pools; shock treatment; any pool needing a fast kill |
Using both sensibly
Many outdoor pools combine the two: TCCA tablets for the steady daily residual, and calcium hypochlorite or liquid hypochlorite to shock the pool and to supply extra chlorine without adding more stabiliser. This works only if the two are kept physically apart. TCCA and calcium hypochlorite must never be mixed, stored together or put through the same feeder, because together they can react violently, generating heat and chlorine gas.
- Measure cyanuric acid regularly; it does not show up in chlorine tests.
- Raise the free chlorine target as cyanuric acid rises, keeping the ratio within your code.
- When stabiliser is too high, the only practical remedy is partial draining and refilling with fresh water.
- Switch to unstabilised chlorine for a period if cyanuric acid is climbing faster than dilution removes it.
Cyanuric acid protects chlorine from the sun but slows its action. Keep it within your code's limits and supplement with unstabilised chlorine when it climbs.
Specifying pool chlorine
State the chlorine compound, form (tablet size, granules or powder) and minimum available chlorine, and whether your operation needs a stabilised product, an unstabilised one or both. Ask for the SDS, the UN number and class for transport, and a certificate of analysis. Nuroil can supply TCCA and calcium hypochlorite on request; see the swimming pool page.
