Technical document

· PDF

Tell us who you are and the document downloads straight away. We use these details only to follow up on your requirement.

Samples & documents

What can we send you?

Tick what you need
Request a quote
Expert article3 min read6 sections

Knowledge centre · Water & pool treatment

Calcium hypochlorite, calcium hardness and scale in pools

How calcium hypochlorite adds calcium hardness, when that leads to scale or cloudy water, and how pool operators keep the saturation index in check.

Written by the Nuroil trade desk, Sharjah

On this page · 6 sections
  1. 01How much calcium each dose adds
  2. 02When calcium becomes a problem
  3. 03Keeping the balance
  4. 04Dosing practice that limits cloudiness
  5. 05Feeders and scale
  6. 06Buying considerations

Calcium hypochlorite is valued as a dry, unstabilised chlorine that adds no cyanuric acid to pool water. What it does add, with every dose, is calcium. In soft water that is often welcome; in hard water, or in pools with little dilution, it can push the water towards scale, cloudy water and blocked feeders. Understanding how much calcium arrives and how it interacts with pH and alkalinity lets operators use calcium hypochlorite without these problems.

How much calcium each dose adds

Calcium hypochlorite, Ca(OCl)₂, carries one calcium ion for every two hypochlorite ions. Working from the formula, each 1 mg/L of available chlorine supplied adds roughly 0.7 mg/L of calcium hardness expressed as calcium carbonate. Commercial products at 65 to 70% available chlorine also contain other calcium compounds and insoluble matter, so the real increase can be a little higher. The figure is small per dose but accumulates, because calcium only leaves the pool with water that is drained, backwashed or splashed out. Evaporation removes water but leaves the calcium behind, concentrating it.

When calcium becomes a problem

Calcium hardness alone does not decide whether scale forms. The tendency of water to deposit calcium carbonate depends on pH, total alkalinity, calcium hardness, temperature and total dissolved solids together. Pool codes commonly express this as a saturation index, calculated from pH plus factors for temperature, calcium hardness and alkalinity, minus a constant. A positive index means the water is supersaturated with calcium carbonate and may deposit scale; a negative index means it is aggressive and may etch plaster and grout.

Because calcium hypochlorite is alkaline as well as calcium-bearing, it nudges two of these factors upwards at once. Typical symptoms when the balance tips:

  • Cloudy water after shock dosing, especially in hard-water areas.
  • White, rough deposits on tiles at the waterline, on steps and on heater elements.
  • Scale in salt cells, heat exchangers and dosing injection points.
  • Crusting and blockage in calcium hypochlorite feeders.

Keeping the balance

MeasureWhy it helps
Test calcium hardness regularlyShows the build-up before scale appears
Calculate the saturation indexCombines pH, alkalinity, calcium and temperature into one figure
Hold pH in the target rangeScale risk rises sharply as pH climbs
Control total alkalinityHigh alkalinity drives pH upward and supports scale
Dilute with fresh waterThe only practical way to lower calcium

Water testing suppliers commonly cite a calcium hardness range of around 200 to 400 mg/L for pools and lower for spas, though the right target depends on the pool surface and local code. In very hard source water, operators may alternate calcium hypochlorite with a non-calcium chlorine source to slow the build-up. That means using the products at different times through their own dosing equipment, never combining them.

Dosing practice that limits cloudiness

  • Pre-dissolve granules in a clean bucket of water, let the insoluble residue settle and add the clear solution, unless the label directs otherwise.
  • Always add the product to water, never water to the product.
  • Add solution slowly in front of a return inlet with the circulation running.
  • Shock in the evening and retest pH the next morning.
  • Do not exceed label doses; very large doses raise calcium, pH and turbidity together.
Calcium hypochlorite is a calcium source as well as a chlorine source. Track hardness and the saturation index, and scale rarely becomes a surprise.

Feeders and scale

Calcium hypochlorite tablet feeders are designed specifically for this product, with water flow that limits scale inside the unit. They need periodic cleaning of scale and residue following the maker's instructions. Never place calcium hypochlorite in a feeder used for TCCA or any other chlorine product, and never mix their residues: the combination can cause fire or explosion.

Buying considerations

When you buy, ask for available chlorine and insoluble matter on the certificate of analysis, since both affect how much calcium and residue each kilogram of chlorine brings. Specify granules or tablets to suit your dosing method, and confirm packing that keeps moisture out. Nuroil supplies calcium hypochlorite on request with a CoA on every delivery; send details through the quote request form.

KEEP READING

More from the Knowledge Centre.

STILL HAVE A QUESTION?

Ask the people who trade it every day.

Our trade managers answer technical and commercial questions about grades, specifications, packing and shipping.

LET’S TALK ABOUT YOUR REQUIREMENTS

Your next shipment starts here.

Request a quote