Technical document

· PDF

Tell us who you are and the document downloads straight away. We use these details only to follow up on your requirement.

Samples & documents

What can we send you?

Tick what you need
Request a quote
Guide3 min read7 sections

Knowledge centre · Water & pool treatment

Checking TCCA quality: available chlorine, tablet checks and the certificate of analysis

How available chlorine in TCCA is measured, which other parameters appear on a certificate of analysis, and how to sample and check a delivery.

Written by the Nuroil trade desk, Sharjah

On this page · 7 sections
  1. 01What available chlorine means
  2. 02How it is measured
  3. 03Parameters on a TCCA certificate
  4. 04Sampling a delivery
  5. 05Simple checks on arrival
  6. 06Safety in the laboratory
  7. 07What to request from the supplier

For trichloroisocyanuric acid (TCCA), the number that matters most is available chlorine: it decides how much product is needed for each dose and whether a delivery is worth what was paid. This guide explains how that figure is determined, what else a good certificate of analysis (CoA) should cover, and how buyers can check a shipment.

What available chlorine means

Available chlorine expresses the oxidising power of a chlorine compound as the equivalent weight of chlorine gas. TCCA's theoretical value is about 91.5%, and commercial grades are commonly specified at around 90%, often with a range of 88 to 92%. A result well below the specification indicates impurities, excess moisture or decomposition.

How it is measured

The standard approach is iodometric titration, covered for chloroisocyanuric acids and their salts in ASTM D2022, which describes both an iodometric-thiosulfate method and an arsenite-iodometric method. In outline:

  1. A weighed sample is dissolved or dispersed with potassium iodide in acidified water.
  2. The active chlorine oxidises iodide to iodine in an equivalent amount.
  3. The iodine is titrated with standardised sodium thiosulfate, using starch near the end point.
  4. Available chlorine is calculated from the titrant volume and the sample mass.

Industrial hygiene work by the US CDC also identifies iodometric titration as the preferred method for chlorinated isocyanurates, while noting it needs a reasonable sample mass to be precise. The laboratory should state which method was used on the CoA.

Parameters on a TCCA certificate

ParameterWhy it matters
Available chlorine (%)Strength; basis for dosing and value
Moisture or loss on dryingMoisture lowers strength and makes the product less stable
pH of a 1% solutionConfirms the expected acidic character; unusual values suggest contamination
AppearanceWhite, free of discoloration and foreign matter
Tablet weight and toleranceFeeder fit and dosing consistency
Tablet diameter and thicknessFit in feeders designed for a given size
Particle size (granules, powder)Dissolution speed and dust
Batch number and production dateTraceability and stock rotation

Ask the supplier which parameters their specification guarantees, since not every producer reports every item.

Sampling a delivery

  • Sample from several drums or bags chosen across the lot, not just the first one opened.
  • Work quickly in dry conditions and close containers immediately; TCCA picks up moisture.
  • Use clean, dry, non-metallic scoops and glass or compatible plastic sample jars with tight lids.
  • For tablets, take whole tablets; the laboratory will grind them under controlled conditions.
  • Label each sample with batch, drum number and date, and keep a retained sample sealed and cool.

Simple checks on arrival

Before laboratory results come back, a few checks catch obvious problems:

  • Drums and liners intact, lids sealed, no damp patches or swelling.
  • No strong chlorine smell on opening, no caking or yellowing.
  • Weigh a set of tablets and compare the average and spread with the stated weight.
  • Check that tablets fit the intended feeder.
A CoA is only meaningful if the method is stated and the batch on the certificate matches the batch on the drums.

Safety in the laboratory

TCCA releases chlorine with acids, which is why the titration is done in small quantities, in a fume cupboard or well-ventilated area, by trained staff. Never return unused sample to the drum, and never mix TCCA residues with other chlorine products in waste containers. Follow the safety data sheet for protective equipment.

What to request from the supplier

Ask for a batch CoA stating available chlorine and the test method, tablet weight data for tablets, the safety data sheet, and, where needed, a certificate of origin and independent inspection with sampling at loading. Nuroil provides a CoA with every delivery and can arrange third-party inspection on request; use the request a quote page to set out your specification.

KEEP READING

More from the knowledge centre.

STILL HAVE A QUESTION?

Ask the people who trade it every day.

Our trade managers answer technical and commercial questions about grades, specifications, packing and shipping.

LET’S TALK ABOUT YOUR REQUIREMENTS

Your next shipment starts here.

Request a quote